lateral bending是什么意思_lateral bending的中文翻译

横向弯曲；侧向弯曲

lateral───adj.侧面的，横向的；vt.横向传球；n.侧部；[语]边音

bending───n.弯曲，弯曲度；v.弯曲（bend的现在分词）

flatwise bending───平面弯曲

lateral view───侧视；侧面图；侧面图，侧面观; 侧视图

lateral epicondylitis───肱骨外上髁炎；[医]（肱骨）外上髁炎

extensile lateral───外展性

bending over───俯身；折转

lateral thinking───n.水平思考；横向思维；水平思考

flexural bending───塑性弯曲

Choose a different bus schedule to be completed mold plane bending, lateral bending and other processes.───选用不同的模具可以完成母线排的平面弯曲、侧向弯曲等加工工艺。

combination of lateral bending plus flexion or lateral bending plus extension strongly increased the maximum shear strains.───合并有侧弯加屈曲或侧弯加伸展的运动很明显地增加了最大切应力。

paper the mechanism of lateral bending deformation of Lear springs is studied.───弹簧的侧向弯曲变形机理进行了分析。

Vertical and lateral bending of the steel roof of the deviation should be allowed to meet the norms.───钢屋架的垂直度和侧向弯曲的允许偏差应符合规范的规定。

After odontoid destabilization, however, this technique was less effective at reducing the lateral bending range of motion.───而齿状突失稳后，这种技术降低侧屈活动范围的效果较差。

A combination of lateral bending plus flexion or lateral bending plus extension strongly increased the maximum shear strains.───合并有侧弯加屈曲或侧弯加伸展的运动很明显地增加了最大切应力。

Morphologic changes of the cervical intervertebral foramen due to lateral bending───颈椎侧弯对颈椎间孔形态的影响

Effect of neck rotation and lateral bending on the blood flow of the vertebral arteries───颈部旋转与侧屈活动对椎动脉血供的影响

hand dumbbell lateral bending, or swivel to do physical exercise, can exercise abdominal, external oblique;───手握哑铃做体侧屈或转体运动，可以锻炼腹内、外斜肌；

By this method, the thermal stress problem in ortho- anisotropic medium can be directed solved from the existing solution of lateral bending problem and vice versa.

Conclusion:Unilateral pedicle screws fixation cannot provide sufficient stability in lateral bending and axial rotation, pedicle screws endure more stress.

An analogy method to solve thermal stress problem and lateral bending problem in ortho -anisotropic mediums is presented in this paper.

The stability with wire fixation was greater and equal to in flexion and in extension, lateral bending and axial rotation respectively.

This article presents design of lateral bending die for sheet metal parts and their forming simulation.

Results The range of motion (ROM) of process wire was less than that of the intact in flexion, extension, lateral bending, but not in axial rotation.

The model and the specimens were loaded with pure unconstrained moments of 7.5 Nm in flexion, extension, lateral bending, and axial rotation.

Lateral bending plus axial rotation yielded the highest increase in fiber strains, followed by axial rotation plus flexion or axial rotation plus extension.